How many questions can I get wrong and still pass the DKT?

You can make a maximum of 6 mistakes total across both sections: General Knowledge Section (15 questions): Maximum 4 wrong answers allowed, Road Safety Section (30 questions): Maximum 2 wrong answers allowed. This means you need at least 39 correct answers out of 45 total questions to pass. If you exceed the error limit in either section, the test will terminate automatically.

How many times can I retake the DKT if I fail?

You can retake the test unlimited times until you pass, all covered by your initial test fee. However, you must wait at least 12 hours between attempts. After each failed attempt, you'll be shown the correct answers to help you prepare for your next try.

What are the consequences of cheating on the DKT?

If caught cheating, you face serious penalties: 6-week ban from taking any driving test, Forfeit your test fee and must pay again when eligible, Cheating includes receiving unauthorized help or using prohibited materials during the test

Can I start driving immediately after passing the DKT?

Yes, once you pass the DKT and receive your learner's licence, you can begin practicing driving immediately. However, you must always drive with a qualified supervisor who holds a full Australian driver's licence.

What makes the DKT challenging for many test-takers?

The main difficulty stems from unfamiliarity with Australian road rules, traffic signs, and safe driving practices. Approximately 30% of all DKT attempts result in failure. Success requires thorough study of the official road rules and understanding of local traffic laws, rather than relying solely on general driving knowledge.

Dashboard
Truck
Study Question
Rigid Vehicles

Rigid Vehicles

Question 1 of 6

Look at the diagram. The diagram shows a rigid truck with a single rear axle fitted with 4 standard tyres. The maximum statutory axle load is:

www.driverknowledgetest.com.au - DKT Online - Look at the diagram. The diagram shows a rigid truck with a single rear axle fitted with 4 standard tyres. The maximum statutory axle load is: - A. 9.0 tonnes.

A. 9.0 tonnes.

Explanation:

"The maximum load on a single rear axle with four tyres is 9.0 tonnes."
B. 13.0 tonnes.
C. 16.5 tonnes.

Previous Next

Question 2 of 6

The driver of a 10 tonne GVM commercial bus (coach) is approaching the sign shown in the diagram. What should the driver do?

www.driverknowledgetest.com.au - DKT Online - The driver of a 10 tonne GVM commercial bus (coach) is approaching the sign shown in the diagram. What should the driver do? - A. Not exceed 40 Km/h.

A. Not exceed 40 Km/h.

Explanation:

"This sign is the maximum speed for trucks and buses."
B. Only drive faster than 40 Km/h if it is safe.
C. Ignore the sign as it only applies to vehicles with a GVM above 15 tonnes.

Previous Next

Question 3 of 6

What is the maximum allowable length of a rigid vehicle, including its load?

A. 12.5 metres.

Explanation:

""
B. 15.5 metres.
C. 14 metres.

Previous Next

Question 4 of 6

You are driving a bus that displays this sign and there are no street lights or houses along the road:

A. You have right of way when you pull out from a bus stop only if you are not crossing a lane line.
B. You do not have right of way when you pull out from a bus stop.

Explanation:

"You do not have right of way."
C. You have right of way when you pull out from a bus stop.

Previous Next

Question 5 of 6

Which vehicle in the diagram are you permitted to drive with a medium rigid licence?

A. Vehicle A.
B. Vehicle B.
C. Vehicle C.

Explanation:

""

Previous Next

Question 6 of 6

Can a driver holding a Medium Rigid (MR) licence drive the type of vehicle shown in the diagram?

A. No.

Explanation:

"Even though bendi-buses are treated as rigid vehicles, you would need an HR licence to drive it as it has three or more axles."
B. Yes.
C. Only if the owner gives special permission.

Previous Pratice